We pair it for you
Bring the vehicle and the new remote to our Markham shop and we’ll pair it to your system.
Ships across Canada from Markham · Installed at our shop or on-site in the GTA

Connects the antenna to the control module
5.0 from 1 verified reviewThe cable only.
Total
This one's out of stock right now. Text us and we'll tell you when it's back
Text us your year, make and modelRuns from the antenna on your windshield to the control module under the dash. Count the pins on the plug at each end of your old cable to pick the right one.
The cable runs from the antenna on your windshield to the control module under the dash. Count the pins on the plug at each end of your old cable: blue plugs have 4 pins, black plugs have 6.
The Compustar antenna cable with a 6-pin black connector at both ends. It carries the signal from the antenna on your windscreen down to the control module under the dash.
Count the pins on the connector at each end of your existing cable, or on the sockets at the antenna and module. This is the 6-pin to 6-pin. We also stock 4-pin to 4-pin and 4-pin to 6-pin.
Most Compustar antennas are sold without a cable, so if you're replacing a failed antenna you'll likely need one of these too.
Free shipping on orders over $200.
Buy it from us and we can set it up for you.
Bring the vehicle and the new remote to our Markham shop and we’ll pair it to your system.
Drop it off or wait at our Markham shop, or we come to you in the GTA. Most installs can be done on-site; a few need the shop.
Every install we do comes with our lifetime installation warranty.
Pairing a remote takes a few minutes and no tools: the steps for your remote are on our Compustar remote support page. Replacing a remote? Try a fresh battery in the old one first. Text us the FCC ID on your remote with any questions.
Verified reviews from our customers.
Check the label on your control module, usually under the driver’s side of the dash, against the list under Will it work with your system?. Not sure which module you have? Text us a photo of the label.
Only if it’s made for that antenna. The quickest check is the FCC ID on the back of your old remote: match it to the one on this page, where the antenna it pairs with is listed too.
A single remote is a spare or a replacement for one you have. A kit has its own antenna, so it’s the way to upgrade, say from 1-way to 2-way, or to replace a remote that isn’t made anymore. See the remote kits.
Try a fresh battery first: key fob batteries. If it still doesn’t work, text us the FCC ID on the back of the remote.
Yes, at our Markham shop. Adding a remote kit during a remote starter install? We do it at the same time, with our lifetime installation warranty. Book an install.
Yes. Shipping is free on orders over $200, and $10 under that.
Text us the FCC ID on your remote, or a photo of your control module’s label, and we’ll confirm the right part before you order.