RydeenBSS3

Rydeen's 24 GHz radar blind spot kit with cross-traffic alerts and a GPS speed threshold. Owner's manual, settings and testing.

Status
Current model
Documents
1 current
BSS3 owner's manual
1.1
Sold as
BSS3

Manuals and guides

For owners

  • BSS3 owner's manual Owner's manual, PDF, 1.1
Setup help

One flash, then two: start-up and GPS

When you start the vehicle, both lights flash once: the system is on. The BSS3 uses a GPS antenna to know your speed, and once it finds satellites, which can take up to 2 minutes, both lights flash twice: it's ready.

If it never gets a GPS signal, it warns at any speed instead, so you may get more warnings in slow traffic. The antenna has to sit where it can see the sky, not under metal trim. Underground parking and garages delay it too.

More answers for the BSS3

Set the speed it starts warning at

The BSS3 stays quiet below a speed you choose, so it isn't warning about every car in slow traffic. The setting is a set of four small switches on the main unit, usually done at install:

  • Switch 1: above 8 km/h (5 mph)
  • Switch 2: above 16 km/h (10 mph)
  • Switch 3: above 24 km/h (15 mph)
  • Switch 4: above 32 km/h (20 mph), the factory setting

If we installed it and you'd like it changed, submit a support ticket and book a few minutes with us.

Cross-traffic alert when reversing

When you back out of a parking spot, the BSS3 watches for vehicles coming from either side. If one is coming, the light for that side comes on and the speaker beeps until it's clear.

It only warns about moving vehicles, not parked cars, posts or people standing still, and not things moving slower than about 8 km/h. Cross-traffic needs the reverse wire connected; if the blind spot warnings work but reversing never warns, that wire is the first thing to check.

Test it on the road

After installing, check both sides before you trust it.

  1. Turn the vehicle on. The warning lights flash briefly as it starts up.
  2. On a multi-lane road, with a helper if you can, let a vehicle come up beside you on the left. The left light should come on.
  3. Put your left signal on while it's there. The light should flash and you should hear the tone.
  4. Repeat on the right. Kits with cross-traffic alert: back out of a parking spot with a car coming down the aisle, safely, with a helper watching.

If the wrong side lights up, the left and right wires are swapped. Radar kits that start warning at a set speed won't react in a parking lot until you're going fast enough.

Warnings when nothing is there, or no warning

A blind spot kit is a second pair of eyes, not a replacement for a shoulder check. Some false warnings are normal: guard rails, concrete barriers, construction barrels, a trailer you're towing, or a vehicle in the lane two over can all set it off for a moment.

  • Warning all the time with nothing there: the sensor or its bracket has moved, or something metal (a hitch, a licence plate frame, a bumper guard) is in front of it.
  • No warnings at all: check the fuse and that the lights flash when you start the vehicle. Ultrasonic sensors also go quiet when they're caked in snow or slush.
  • After a bumper repair: body filler and new paint can change how a radar sees. Have the aim checked.

If we installed it and it's still not right, submit a support ticket: our installation is covered for life.

Setup video

From the Lockdown Security YouTube channel