RostraBackZone Plus 2501903BZP

Rostra's 4-sensor rear parking sensor kit with a colour distance display. User guide, reading the display, settings and fault help.

Status
Current model
Documents
1 current

Manuals and guides

For owners

  • BackZone Plus user and installation guide Owner's manual, PDF
Setup help

Reading the display

The BackZone Plus comes on when you shift into reverse and beeps once to say it's ready. Then:

  • Green: something is 1.1 to 2.5 m behind you.
  • Yellow: 50 cm to 1.1 m. Slow down.
  • Red: 28 to 50 cm. Be ready to stop.
  • -P- (stop): under 28 cm. Brake now. Anything closer than 28 cm can't be measured.

The bands on the left and right show which side the obstacle is on, and the beeps speed up as it gets closer. Keep your speed under about 5 km/h when reversing so the system can keep up.

More answers for the BackZone Plus 2501903BZP

Volume, and mounting the display on the visor

The display has a switch for the beeper: high, low or off. With it off you still get the colour bands and the distance.

It can sit on the dash, or hang upside down on the sun visor. If you mount it upside down, flip the rotate switch on the display so the readout is the right way up.

Test the sensors after installing

Test before you rely on it. You need a helper and something flat, like a sheet of plywood about 30 cm by 1 m.

  1. Park somewhere with nothing behind you, start the vehicle and shift into reverse. It should beep once (or show a clear display) to say it's working.
  2. Have your helper stand the board up about 2 m behind the bumper, then walk it slowly toward the vehicle. The warnings should speed up as it gets closer.
  3. Repeat behind each corner and the middle, so you know every sensor sees.
  4. Front sensors: press the brake to wake them up, then do the same in front of the bumper.

A sensor that never reacts is usually unplugged, or aimed at the ground. Check its plug at the control unit first.

Fault warning, or the wrong side lights up

For three seconds after it comes on, the BackZone Plus checks its sensors and warns you on the display if one isn't working. It still runs, but that corner may not be covered.

  • Clean the sensors: snow, ice and salt are the usual cause.
  • The sensors and their plugs are numbered 1 to 4 and must go in order. If an obstacle on the left shows up on the right, two sensors are swapped.
  • Still a problem? Submit a support ticket. The kit has a 3-year Rostra warranty.
False alerts in rain, snow or slush

Ultrasonic sensors need a clean face to work. Heavy rain, ice, slush, mud or a layer of road salt can make them beep at nothing, or miss things. Wipe them with a soft cloth or rinse them with low-pressure water. Don't blast them with a pressure washer up close or scrape them, and melt off ice rather than chipping it.

Rough ground, tall grass, and steep driveways can also set them off. If one sensor keeps alerting on a clean, dry day, it may be loose or aimed too low: submit a support ticket and we'll check it.