KEETEC Rider Support

EMERGENCY DISARM

ATTENTION: The PIN code from the owner’s card cannot be changed or issued a duplicate, so we recommend keeping the card in a safe place.

Emergency deactivation is used for one-time authorization of the driver in the event the absence of the remote control (loss of the remote control, discharge of the battery in the remote control).

NOTICE: Validity of the emergency deactivation is limited to 1 minute. For this reason, it is necessary to start the vehicle within one minute from the successful emergency deactivation.

Deactivation procedure:

• Press and hold the service button until the LED indicator lights up (approx. 2 seconds).

• Release the button.

• Press the service button as many times as the value of the first digit of the PIN code, the LED indicator will flash 3 times.

• Press the service button as many times as the value of the second digit of the PIN code, the LED indicator will flash 3 times.

• Press the service button as many times as the value of the third digit of the PIN code, the LED indicator will flash 3 times.

• Press the service button as many times as the value of the fourth digit of the PIN code, the LED indicator flashes 3 times, the system is deactivated once and the buzzer beeps 2 times briefly.

SERVICE MODE

The service mode can be activated with the service button or the remote control.

CONDITION: To activate the service mode, at least one of the conditions for a valid authorization must be met:

1. Remote control is present in the vehicle.

2. System was authorized in an emergency by entering the PIN code from the owner’s card (see EMERGENCY DISARM).

Activation of service mode by remote control

Turn on the ignition or start the vehicle, press and hold the button on the remote until the LED on the remote goes out. The activation of the service mode is announced by the buzzer beeping 5 times.

Activation of service mode with service button PIN code entry procedure:

• Press and hold the service button until the LED indicator lights up (approx. 2 seconds).

• Release the button.

• Press the service button as many times as the value of the first digit of the PIN code, the LED indicator will flash 3 times.

• Press the service button as many times as the value of the second digit of the PIN code, the LED indicator will flash 3 times

• Press the service button as many times as the value of the third digit of the PIN code, the LED indicator will flash 3 times

• Press the service button as many times as the value of the fourth digit of the PIN code, the LED indicator will flash 3 times

• The activation of the service mode is announced by the buzzer beeping 5 times. The PIN code is indicated on the owner’s card.

The active service mode is signaled by the permanently lit service button LED while the ignition is on.

Deactivation of service mode by remote control

Turn on the ignition or start the vehicle, press and hold the button on the remote until the LED on the remote goes out. The deactivation of the service mode is announced by the buzzer beeping 5 times.

Deactivation of service mode with service button

Enter the service PIN code using the service button in the same way as for activation. Deactivation of the service mode is announced by 5 beeps of the buzzer.